Saab 95 1967, Service Manual

Page: 154 / 610

0.|pan. I'UDILIUII tun. LVVU UUIlS
and secure the
10‘ "man at the rear balance shaft
with the rubber washers
bearing.
PISTON ASSEMBLY FITTING THE TWO BOLTS WITH RUBBER WASHERS
Tool 78 62 287
11. Lubricate the tappets and their bores with engine
oil and install the tappets in the same sequence as
they were originally fitted.
12. Install the cylinder head gaskets. The gaskets are
marked "Front" and “Top”.
5. If new bearings are installed check that the correct
clearance is obtained. The measuring procedure is
described in this section.
6. Install the bearing inserts dry in the connecting rods
and then coat them with engine oil. Put on the bear-
ing caps and tighten to the prescribed torque.
7. Slide the oil pump onto its drive shaft and install it
with the gasket. Tighten the actual pump bolts first
and then the suction line bolt.
8. Insert the rubber seal in the groove in the rear main
bearing cap.
VURNCHEN
‘ FRONT TOP
INSTALLATION
OF CYLINDER HEAD GASKET
13' '"Z‘al' the complete cylinder heads, insert the bolts
:1 tlghten them in the sequence indicated in three
ages to the correct torque according to the follow-
ing
table:
INSTALLATION OF OIL PAN GASKET Ni“ kpm ft.lb.
1' 54 5.5 40
Z 69 7.0 so
9. Apply a coat of sealing compound to the two cor- 3' 93 9.5 68
ner joints where the transmission cover, the inter-
mediate plate and the edges of the oil pan meet
. . .
POSlthn the Oil pan gasket on the block and insert To ensure effective :ZSrngN‘LO
- e Its must be tight-
the two tabs on the cork gasket under the recesses
in the rear bearing cap rubber seal.
216—6