Saab 95 1967, Service Manual

Page: 254 / 610

Alignment towards a screen
The various lines on the screen correspond to: the center
""9 Of the car 1. the vertical center lines of the two head- 6. If the high beams ar
lights 2—2, and the horizontal center lines of the head-
lights 3—3.
1. Check the tire pressure and load the car as it would
normally be loaded.
2. Up to and incl. model 1973: Remove the trim frame
so that the adjusting screws are accessible. Put the car
25 ft. (7.6 m) from the screen.
3. Switch on the high beam end shield one headlight at
a time.
4. Check and adjust the headlight so that the beams come
2 in. (50 mm) under the intersections of lines 2—2 and
3—3. The tolerance limits which may not be exceeded
by the center of the beam under any circumstances are
marked by the black area on the screen. The transver-
sal limits are 6 in. (150 mm) to the right or left of line
2—2, and vertically the center of the beam may not be
above line 3—3 or more than 4 in. (100 mm) below
line 3—3.
III! VII/I4 ’II II. ’IIIIIIIII.
{5227/
ALIGNMENT OF SEALED BEAM UNITS
1. Center line of car
2—2. Vertical center line of headlight
3—3. Horizontal center line of headlight
A = 2 in. (50 mm)
B = 6 in. (150 mm)
C = 10.5116 in. (415 mm)
351—4 SAAB
symmetric. If
rect setting, fit a ne
necessary to adjust t
and make sure that the beam is
adli hts .
5, Check both hemt gar if it proves difficult to get a cor-
w Sealed Beam unit.
e correctly aligned it will not be
he dipped beams separately.