Saab 95 1967, Service Manual

Page: 559 / 610

UUUH" r‘l" I-IIJU
NOTE
DOORS Be CGII'Gful "Gt to damage the front fender when
°pen|n9 the door without the door stop being
RemOVal fitted.
Remove the interior door trim.
5- Adjust the door in the Ion ' ‘ ' ' h
Z Relisegtehe door stop by drivmg out the pm at the up- car by advancing or backing off the nuts a little at a
per In ' time. To adjust the vertical ' '
3. Let the door rest on a suntable support or suspend it it UP or down in the elongated holes after loosening
in a suitable way in order to relieve the hinges of its the nuts slightly
weight. k' _ 6- When the door is correctly positioned and fits snugly
4' Bend back the loc mg tabs for the externally me“ against the weather strips, tighten the nuts and secure
"Uts' . _ With the locking tabs.
5‘ Back off the two nuts, accessible from mode the door, 7. Refit the door stop Pin and the interior trim.
and remove the door.
NOTE
Be careful not to damage the outside of the door
Window regulator
with the tools used to release the nuts. Removal and installation
\_
1. Remove, the door trim.
2. Back off the four nuts accessible through the hole in
the toothed segment of the window regulator, holding
the window pane in position meanwhile. The screws
can than be removed.
3. Release the control arm pin from the retainer groove
and remove the window regulator.
REMOVAL
OF DOOR
REMOVAL OF WINDOW REGULATOR
6. Remove the hinges from the body.
To reinstall the window regulator, proceed in the reverse
Installation and adjustment order to that given above.
1. Refit the hinges to the body. of previOUS'Y '°m°"e‘.j'
Also fit the inner locking nuts on the hinge pivot pins-
2- Block up or suspend the door in the correct Pos'm"
and pass it onto the hinge pivot pin5
3- Refit the washers and hinge nuts inside the
4- Check carefully to see if the door fits properly '"to
the Opening.
sun_1