Saab 95 1967, Service Manual

Page: 128 / 610

21.
22.
23.
2147
and secure it with the nine retaining
78 6 Hate installation of the water pump,
cured to the transmission
. k-
Turn the crankshaft until the mark on the cran boItS- To fa“
shaft gear faces the camshaft. the I .
- ‘ ‘ he en me.
Pass the camshaft gear onto the cams tailed on t g
the mark coincides with the m
gear. Secure the camshaft gear With a re
and washer.
Install the balance shaft gear so that t
aides with the mark on the cranks
haft so that .5 ms
ark on the crankshaft cover before this
taining bolt
he mark coin-
haft gear.
INSTALLATION
OF TRANSMISSION COVER
5 I I42 1. Transmission cover
2. Centering arbor 78 62 147
INSTALLATION MARKS, TRANSMISSION GEAR
24.
INSTALLATION OF TRANSMISSION COVER OIL SEAL
Tool 78 62 I54
25.
Install
a new balance shaft pulley seal in the trans- 26. Lubricate the inner diameter of the balance shaft
missnon cover, uslng t0°I 73 62 154- pulley seal with engine oil. Align the pulley kW
WEN with the balance shaft key and install the PU"
Iey, the flat washer and the retaining bolt.
27. Insert the oil pump drive shaft in the block with
the pointed end first.
Th NOTE
e stop plate on the shaft must be positioned 5.02
in. (127.5 mm) from the blunt end.
um
Apply a thin coat of sealing compoUnd to the gas-
ket mounting surfaces on the intermediate Plate
and transmission cover. Position the "anSMissio
cover gasket against the intermediate plate, Centn
the transmission cover with the special pilot tooier
anti
0