Saab 95 1967, Service Manual

Page: 198 / 610

From this position, it is possible to withdraw the right‘
hand pipe through the hole in the engine compartment
floor.
RIGHT-HAND
PIPE IS WITHDRAWN THROUGH THE HOLE
IN THE FLOOR
Pull the left<hand pipe of the muffler down and to the
left. At the same time, rotate the muffler so that the
right-hand pipe is moved backwards under the car to-
wards the left front wheel.
RIGHT-HAND
PIPE IS MOVED TOWARDS THE LEFT FRONT
WHEEL
The left-hand pipe can now be removed through the hole
in the engine compartment floor.
LEFT—HAND
PIPE is REMOVED THROUGH THE HOLE IN
THE FLOOR
252-2
CAUTION
del 1973, the guard pipes between the
mo spacers were discontinued.
fitted when a muffler is re-
cars which previously
During
front muffler and the
These should not be re
placed. This also applies to
had guard pipes-
Assembly
and muffler pipe in the hole in the en-
Then move the right-hand
9"” (fzrvfard towards the right'hand hole m the floor.
p|p:he same time, lift the left-hand W33 0V”. the start-
Ai’tmotor towards the engine PIOCK' From th'5 p05ition,
e
rt the right-hand pipe through the hole in the floor.
nnection to the engine. Fit
ffler over the pin bolts
1. Insert the left-h
inse
2. Raise the muffler for co
the spacers, position the mu
and screw on the nuts. .
3 Fit the exhaust pipe to the muffler and tighten the
clamp.
4. Loosely fit the hr
pipe and engine mounting. .
5. Position the muffler so that there is clearance be-
tween the pipes and the edge of the hole in the floor
and ensure that the muffler is clear of the sump.
Tighten the muffler, brackets and clamps.
6. Connect the starter motor cable, battery cables, pre-
heater cover, snorkel and air cleaner.
7. Lower the car and replace the hood.
ackets and clamps to the muffler
Sealing between muffler and engine block
In the event of leakage between the muffler and the en-
gine block, tighten the bolts. If this doesn't help, new
gaskets must be fitted. Tighten the bolts carefully to
avoid damaging the flanges.
Sealing between mufflers and exhaust pipe
In the event of leakage at the connection between the
exhaust pipe and the front muffler or between the ex-
haust pipe and the rear muffler, carry out the following
measures:
1. Undo the clamp.
2. Push the exhaust pipe into the
“on. r pipe connec
Check that the exhaust pipe is not out of true, whim
wou d cause stresses at the connections.
4. '
Secure the clamp by tightening its bolt and nut. If
11:: mfeasures prove inadequate, check the align-
o the pipe and straighten if necessary.