Configuration Guide MSTP Configuration
Topology
Configuration Steps
1)
Configuring Switch A
# Set interface Gi0/1 and Gi 0/2 as Trunk port and create VLAN 2 and VLAN 3
Ruijie#
configure terminal
Enter configuration commands, one per line. End with CNTL/Z.
Ruijie(config)#
interface
gigabitEthernet 0/1
Ruijie(config-if)#
switchport mode trunk
Ruijie(config-if)#
exit
Ruijie(config)#
interface
gigabitEthernet 0/2
Ruijie(config-if)#
switchport mode trunk
Ruijie(config-if)#
exit
Ruijie(config)#
vlan
2
Ruijie(config-vlan)#
exit
Ruijie(config)#
vlan
3
Ruijie(config-vlan)#
exit
# Set the spanning tree to MSTP mode, VLAN 2-Instance 1 and VLAN 3-Instance 2
mapping, and set the MST configuration name to Ruijie, MST Revision Number to 1.
View the MST configurations and enable the spanning tree protocol.
Ruijie(config)#
spanning-tree mode mstp
Ruijie(config)#
spanning-tree mst configuration
Summary of Contents for RG-S2900G-E Series
