Ruijie RG-S2900G-E Series, Configuration Manual

Page: 684 / 943

Configuration Guide NFPP Configuration
Command Function
Ruijie(config) # cpu-protect
sub-interface
{ manage|protocol|route }
percent percent_vaule
Configure the packet percent.
percent_value : ranging from 1 to 100, in integer.
For example:
Ruijie(config)# cpu-protect sub-interface manage percent 60
Ruijie(config)# end
Caution
The valid percent value of one packet must be less than 100%
minus the percent value of other two types of packets
Anti-attack Protocols

ARP-guard

IP-guard

ICMP-guard

DHCP-guard

DHCPv6-guard

ND-guard

NFPP syslog
ARP-guard
ARP-guard Overview
The IP address is translated into the MAC address by ARP protocol in the local
area network(LAN). ARP protocol plays an important role in the network security.
ARP DoS attack sends a large amount of illegal ARP packets to the gateway,
preventing the gateway from providing the services. To deal with this attack, on
one hand, you can configure the rate-limit of the ARP packet, on the other hand,
you can detect and isolate the attack source.
The ARP attack detection could be host-based or port-based. Host-based ARP
attack detection could be classified into the following two types again: source IP
address/VID/port-based and source MAC address/VID/port-based. For each
attack detection, you can configure the rate-limit threshold and warning
threshold. The ARP packet will be dropped when the packet rate exceeds the