Rowe RC 4000 + 6000, Operating Instructions Manual

Page: 51 / 383

Chapter 3: Using the ROWE RS / RC / RCS 4000 + 6000 for copying 51
2. The first line of the display shows "System starting". After one
minute, the first line of the display will show "ZOOM 100 %".
Switching on the ROWE RS / RCS 4000 + 6000
The ROWE network multifunction device RCS 4000 + 6000 is
switched on via the power switch on the rear of the device.
[41] On/Off switch on the rear of the ROWE RS/RCS network printer
3. Set the ON/OFF switch on the left rear of the printer to position "I"
[Fig. 41]. The switch will light.
4. The green power LED on the operator panel lights. See [Fig. 42.
Also see Fig. 7 on page 28].
[42] Power LED on the operator panel
5. The first line of the display shows "Please wait". The second line
represents the warm-up period. The warm-up phase of the printer is
completed after reaching the fusing temperature and your system is
ready for operation. The first line of the display shows "Ready for
printing".
6. The display will show "Save energy" instead of "Please wait" if the
energy-saving mode was activated and the printer would start the
warm-up phase only after the first print job has been sent. [Chapter
15 / Energy-saving mode]