Riken Keiki GD-3EC, Technical Manual

Page: 72 / 177

4. Installation 4-7 Connecting the power and signal cables
72 / 168
When using a flathead screwdriver to connect to TN1 on the SD-3, connect the cable to the terminal plate as
follows:
1 Insert the flathead screwdriver into the
screwdriver slot (rectangular hole) in the terminal
plate as shown in the figure to the right.
2 With the flathead screwdriver still being inserted,
insert the cable into the wire insertion hole (round
hole) until it contacts the end.
3 Release the flathead screwdriver.
The cable is now connected to the terminal plate.
Gently pull on the cable to confirm that it is correctly connected.
Avoid pulling with excessive force.
Flathead
screwdriver
Screwdriver slot
Wire
insertion
hole
Cable