Riken Keiki GD-3EC, Technical Manual

Page: 61 / 177

4. Installation 4-7 Connecting the power and signal cables
61 / 168
9 Mount the terminal plates on the terminal plate board.
Adjust the cable position so that no load is applied to the
terminal plates.
10 Return the display unit to its original position and
secure with the two M3 screws.
Take care not to trap the cable here.
11 Rotate the cover clockwise to attach and secure with
the single M4 hex socket set screw.
Use a hex key wrench (2 across flats) to tighten the M4 hex
socket set screw.
Take care not to trap the cable when attaching the cover.
Rotate the cover clockwise until it moves no further to
securely fasten in place.
*The diagram illustrates the SD-3. The connection method for the SD-3SC is identical.
Power and signal terminal plate
Contact output terminal plates