Riken Keiki GD-3EC, Technical Manual

Page: 62 / 177

4. Installation 4-7 Connecting the power and signal cables
62 / 168
4-7-3 Connecting the power and signal cables to the remote sensor head (GD-3)
1 Unscrew the single M4 screw on the remote sensor head
(GD-3) cover.
Use a hex key wrench (2 across flats) to unscrew the M4 hex
socket set screw.
Be careful to avoid dropping the cover while unscrewing and
removing it.
2 Rotate the cover counterclockwise and remove.
3 Attach a cable gland or conduit to the connector on
the remote sensor head (GD-3).
Use an appropriate cable gland or conduit to suit the
purpose and type of the cable.
4 Pull out the terminal plate (TN1) from the terminal plate
board.
Cable gland
Terminal plate
Terminal
plate
Hex key wrench