Ricoh MP C305SPF, Field Service Manual, Page: 98 / 146

0-7
Memory transmission: Interval
between dialing attempts to the
same destination
01 – FF (Hex) minutes
Communication Switch 13 – Not used (do not change the settings.)
Communication Switch 14 (SP No. 1-104-021)
No Function Comments
0
Inch-to-mm conversion during transmission
0: Disabled, 1: Enabled
0: In immediate transmission, data scanned in
inch format are transmitted without conversion.
In memory transmission, data stored in the SAF
memory in mm format are transmitted without
conversion.
Note: When storing the scanned data into SAF
memory, the fax unit always converts the data
into mm format.
1: The machine converts the scanned data or
stored data in the SAF memory to the format
which was specified in the set-up protocol
(DIS/NSF) before transmission.
1-5 Not used Do not change the factory settings.
6-7
Available unit of resolution in which fax
messages are received
For the best performance, do not change the
factory settings.
The setting determined by these bits is
informed to the transmitting terminal in the pre-
message protocol exchange (in the DIS/NSF
frames).
Bit 7 Bit 6 Unit
0 0 mm
0 1 inch
1 0 mm and inch
1 1 Not used
Communication Switch 15 – Not used (do not change the settings)
Communication Switch 16 – Not used (do not change the settings)
4. Service Tables
96