Ricoh MP C305SPF, Field Service Manual, Page: 34 / 146

Code Meaning Suggested Cause/Action
0-52
Polarity changed during
communication • Check the line connection.
Retry communication.
0-55 FCU does not detect the SG3.
• FCU firmware or board defective.
• SG3 firmware or board defective.
0-56
The stored message data
exceeds the capacity of the
mailbox in the SG3.
• SG3 firmware or board defective.
0-70
The communication mode
specified in CM/JM was not
available
(V.8 calling and called
terminal)
• The other terminal did not have a compatible
communication mode (e.g., the other terminal was a
V.34 data modem and not a fax modem.)
• A polling tx file was not ready at the other terminal
when polling rx was initiated from the calling
terminal.
0-74
The calling terminal fell back to
T.30 mode, because it could
not detect ANSam after
sending CI.
• The calling terminal could not detect ANSam due to
noise, etc.
• ANSam was too short to detect.
• Check the line connection and condition.
• Try making a call to another V.8/V.34 fax.
0-75
The called terminal fell back to
T.30 mode, because it could
not detect a CM in response to
ANSam (ANSam timeout).
• The terminal could not detect ANSam.
• Check the line connection and condition.
• Try receiving a call from another V.8/V.34 fax.
0-76
The calling terminal fell back to
T.30 mode, because it could
not detect a JM in response to
CM
(CM timeout).
• The called terminal could not detect a CM due to
noise, etc.
• Check the line connection and condition.
• Try making a call to another V.8/V.34 fax.
0-77
The called terminal fell back to
T.30 mode, because it could
not detect a CJ in response to
JM
(JM timeout).
• The calling terminal could not detect a JM due to
noise, etc.
• A network that has narrow bandwidth cannot pass
JM to the other end.
• Check the line connection and condition.
• Try receiving a call from another V.8/V.34 fax.
3. Troubleshooting
32