Ricoh MP C305SPF, Field Service Manual, Page: 32 / 146

Code Meaning Suggested Cause/Action
0-16
CFR or FTT not detected after
modem training in confidential
or transfer mode
• Check the line connection.
• Replace the FCU.
• Try adjusting the tx level and/or cable equalizer
settings.
• The other end may have disconnected, or it may be
defective; try calling another machine.
• If the rx signal level is too low, there may be a line
problem.
Cross reference
See error code 0-08.
0-17
Communication was
interrupted by pressing the
stop key • If the Stop key was not pressed and this error keeps
occurring, replace the operation panel or the
operation panel drive board.
0-20
Facsimile data not received
within 6 s of retraining
• Check the line connection.
• Replace the FCU.
• Check for line problems.
• Try calling another fax machine.
• Try adjusting the reconstruction time for the first line
and/or rx cable equalizer setting.
Cross reference
Reconstruction time - G3 Switch 0A, bit 6
Rx cable equalizer - G3 Switch 07 (PSTN)
0-21
EOL signal (end-of-line) from
the other end not received
within 5 s of the previous EOL
signal
• Check the connections between the FCU and line.
• Check for line noise or other line problems.
• Replace the FCU.
• The remote machine may be defective or may have
disconnected.
Cross reference
Maximum interval between EOLs and between ECM
frames - G3 Bit Switch 0A, bit 4
3. Troubleshooting
30