SERVICE MANUAL
Page 845
CHAPTER 8
9107
May/12
Page 845
Oct/11
CHAPTER 8
283
SERVICE MANUAL
ISO 9650
6.5 With the heat gun at setting at 6, apply heat evenly over the heat-shrink
sleeve. The rear of the heat-shrink sleeve should be heated evenly from both
left and right hand sides, (FIGURE 841).
6.6 Ensure that the entire crimp and tail are completely encapsulated and that
the heat-shrink sleeve overlaps in both directions by at least 5 mm.
6.7 Using protective gloves, pinch the ends of the heat-shrink while it is cooling,
to ensure that they have sealed tight against the strap.
7. Container labelling
7.1 Check that all labels are fitted and positioned correctly and securely. Please
refer to Chapter 11, Section 3 Container label identification and position.
7.2 Record the liferaft details, onto the liferaft identification label and insert it into
the identification tube. Check for legibility and correct details.
7.3 The liferaft identification container and any excess tether webbing shall be
tucked between the container strapping and the container.
7.4 Tape the IAL compact disc to the container.
This completes the packing sequence and the liferaft is now ready for installation.
