Page 806
CHAPTER 8
May/12
9107
SERVICE MANUAL
Page 806
Feb/11
CHAPTER 8
283
SERVICE MANUAL
ISO 9650
Internal lamp installation
FIGURE 805
Installing the Internal RL5 Lamp unit
WARNING:
KEEP THE INTERNAL LAMP UNIT AWAY FROM ANY SOURCE
OF IGNITION. DO NOT HEAT THE INTERNAL LAMP UNIT
ABOVE 65 ºC OR BURN IT. THE CONTENTS OF THE POWER
UNIT ARE FLAMMABLE. REFER TO THE MANUFACTURER’S
DATA SHEET.
WARNING:
DO NOT OPEN, CRUSH OR PUNCTURE THE INTERNAL
LAMP UNIT. THE CONTENTS OF THE BATTERY ARE TOXIC
AND CORROSIVE. REFER TO THE MANUFACTURER’S DATA
SHEET.
WARNING:
IF THE CHEMICALS FROM THE INTERNAL LAMP UNIT
BATTERY TOUCH SKIN, CLOTHING OR EQUIPMENT, WASH
THEM WITH LARGE QUANTITIES OF COLD WATER. REFER
TO THE MANUFACTURER’S DATA SHEET.
Internal unit
The RL5 internal lamp is inserted into the existing retaining patch on the
bottom center line of the arch-tube, inside the raft.
2.1.15 Remove the protective cup and disc from the external lamp
connector.
2.1.16 Attach the switch activator as shown in (FIGURE 805). Ensure the ‘O’
ring is seated correctly.
2.1.17 Locate the internal lamp retaining patch located on the bottom center
line of the arch-tube, inside the liferaft (FIGURE 806).
