SERVICE MANUAL
Page 841
CHAPTER 8
9107
May/12
Page 841
Oct/11
CHAPTER 8
283
SERVICE MANUAL
ISO 9650
5.60 Container or valise
5.60.1 Container
: Place the top half of the container over the H-Pack.
5.60.2 Valise
: Remove the sealed liferaft and corrugated card from the
container. Place the top of the valise over the liferaft, while using
the corrugated card as a guide. When the liferaft and card are fully
inside, the valise can then be zipped closed.
5.61 Please refer to Chapter 5 Testing and Trouble shooting, to perform the post
operational packing vacuum test, (POPVT).
5.62 If the POPVT is successful, position the Identification tube ring at the edge of
the container. Tape it securely into place.
5.63 Check that the painter retaining plug/ grommet has not become displaced.
WARNING:
WHEN TENSIONING OR CRIMPING STRAPS, THE OPERATOR
MUST STAND TO ONE SIDE OF THE STRAP. PROPER
CLOTHING AND EYE PROTECTION MUST BE WORN. PROPER
FOOTING AND BALANCE MUST BE MAINTAINED WHEN
OPERATING THE EQUIPMENT. USE SHORT HAND STROKES
ONLY DURING TENSIONING.
WARNING:
TOO MUCH TENSION WILL BREAK THE STRAP. THIS MAY
RESULT IN INJURY TO PERSONNEL.
CAUTION:
FOR ALL LIFERAFTS, IT IS ESSENTIAL THAT CRIMPS
ARE ATTACHED ON THE OPPOSITE SIDE OF THE
CONTAINER TO THE ROLL OF THE LIFERAFT
CAUTION:
ENSURE CORRECT CRIMPING TOOLS ARE USED.
(PLEASE REFER TO IPL FOR CORRECT LIST).
