Page 842
CHAPTER 8
May/12
9107
SERVICE MANUAL
Page 842
Feb/11
CHAPTER 8
283
SERVICE MANUAL
ISO 9650
5.64 Obtain the straps and crimps. Tension and crimp each strap as follows:
5.64.1 Adjust the ends of each strap so that the outer most strap end is
facing upwards and is approximately 25 mm above the rim of the
container, (FIGURE 840).
5.64.2 Apply the tensioning tool to the strap at a point half way across the
two rims. Operate the handle to tension the strap until the base of the
tensioning tool rests in the lower container rim. Secure the strap with
a crimp, (FIGURE 840), using the crimping tool.
NOTE:
It is acceptable to wrap the crimps with several layers of
white PVC tape.
5.65 Put ‘DO NOT CUT’ tape over the top of the straps in each recess of the
container.
5.66 Remove the rachet straps if used.
5.67 This completes the packing sequence for the Flat Pack, Throw Over liferaft
The container is now ready for labelling. Please refer to Chapter 11 for
container labelling.
