R&S FSV-K7, Operating Manual, Page: 180 / 262

Analog Demodulation Option R&S FSV–K7
R&S
®
FSV-K7/K7S
180 Operating Manual 1176.7561.02 ─ 06
Parameters:
<Level> <numeric value>
Range:
70.711 nV to 7.071 V
*RST: 1 V
Example: INP:DIQ:RANG 1V
Mode: A, IQ, NF, TDS, VSA, CDMA, EVDO, WCDMA, ADEMOD, GSM,
OFDM, OFDMA/WiBro, WLAN
Manual operation: See "Full Scale Level" on page 78
INPut:DIQ:RANGe[:UPPer]:UNIT <Unit>
Defines the unit of the full scale level (see "Level Unit" on page 78). The availability of
units depends on the measurement application you are using.
This command is only available if the optional R&S Digital I/Q Interface (option
R&S
FSV-B17) is installed.
For details see the R&S Digital I/Q Interface (R&S FSV-B17) description of the base
unit.
Parameters:
<Level> V | dBm | dBpW | W | dBmV | dBuV | dBuA | A
*RST:
Volt
Example: INP:DIQ:RANG:UNIT A
Mode: IQ, VSA, EVDO, CDMA, WCDMA, GSM, ADEMOD, TDS
Manual operation: See "Level Unit" on page 78
INPut:DIQ:SRATe <SampleRate>
This command specifies or queries the sample rate of the input signal from the R&S
Digital I/Q Interface (see
"Input Sample Rate" on page 78).
Note: the final user sample rate of the R&S FSVA/FSV may differ and is defined using
SENSe:ADEM:SRATe
(see
[SENSe:]ADEMod:SRATe?
on page 143).
This command is only available if the optional R&S Digital I/Q Interface (option
R&S
FSV-B17) is installed.
For details see the R&S Digital I/Q Interface (R&S FSV-B17) description of the base
unit.
Parameters:
<SampleRate> Range: 1 Hz to 10 GHz
*RST: 32 MHz
Example: INP:DIQ:SRAT 200 MHz
Mode: A, IQ, NF, TDS, VSA, CDMA, EVDO, WCDMA, ADEMOD, GSM,
OFDM, OFDMA/WiBro, WLAN
Remote Commands of the Analog Demodulation (R&S FSV–K7)