R&S CMW-KM5 Series, User Manual

Page: 538 / 856

LTE Multi Evaluation Measurement
R&S
®
CMW-KM5xx/-KS5xx
538 User Manual 1173.9628.02 ─ 16
View Filter Throughput
Percentage of measurement intervals where the detected signal configuration was
found to correspond to the "View Filter" settings. Only slots which contribute to the
"View Filter Throughput" are displayed, counted, and used for the statistical results;
other slots are rejected. For filter settings see
chapter 3.3.5, "Measurement Control
Settings" , on page 546.
The "View Filter Throughput" is evaluated in a moving window of 1000 frames. If a
non-matching signal configuration is changed according to the "View Filter" settings,
the throughput increases linearly from 0 % to 100 %.
3.3 GUI Reference
The following sections provide detailed reference information on the Graphical User
Interface (GUI) and the parameters of the "LTE Multi Evaluation" measurement.
● Measurement Control ............................................................................................538
● Accessing Parameters and Settings ..................................................................... 539
● Signal Routing and Analyzer Settings ...................................................................539
● Carrier Aggregation Settings .................................................................................543
● Measurement Control Settings ..............................................................................546
● Trigger Settings .....................................................................................................560
● Limit Settings .........................................................................................................563
● Additional Softkeys and Hotkeys ...........................................................................564
● Measurement Results ........................................................................................... 565
3.3.1 Measurement Control
The measurement is turned on or off using the ON | OFF or RESTART | STOP keys.
See also: "Measurement Control" in the R&S CMW user manual, chapter "System
Overview"
Multi Evaluation (Softkey)
The softkey shows the current measurement state. Additional measurement substates
can be retrieved via remote control.
Remote command:
INITiate:
​
LTE:
​
MEAS<i>:
​
MEValuation
​
ABORt:
​
LTE:
​
MEAS<i>:
​
MEValuation
​
STOP:
​
LTE:
​
MEAS<i>:
​
MEValuation
​
FETCh:
​
LTE:
​
MEAS<i>:
​
MEValuation:
​
STATe?
​
FETCh:
​
LTE:
​
MEAS<i>:
​
MEValuation:
​
STATe:
​
ALL?
​
GUI Reference
深圳德标仪器
135-1095-0799