LTE Signaling
R&S
®
CMW-KM5xx/-KS5xx
74
User Manual 1173.9628.02 ─ 16
2.2.20.1
Performing RLC Throughput Measurements
To measure the RLC throughput, you must set up a connection in data application
mode and generate IP traffic.
1. Set up a connection as described in
chapter 2.3.2, "LTE IP-Based Data Tests"
on page 79.
The required options are also listed there.
2. Use the Data Application Unit (DAU) to generate IP traffic in the direction to be
measured (uplink and/or downlink). You may for example perform an IPerf mea-
surement. Or you could transfer data via FTP.
For details refer to the DAU documentation.
3. Start the RLC throughput measurement and evaluate the results.
2.2.20.2
Measurement Results
All results of the measurement are shown on the "RLC Throughput" tab. The results
are described below.
Fig. 2-29: RLC throughput tab
Diagram
The diagram provides a graphical presentation of the data throughput results for the
previous measurement cycle. The X-axis indicates the processed subframes, with the
last processed subframe labeled 0, the previously processed subframe labeled -1, and
so on.
General Description
深圳德标仪器
135-1095-0799
