R&S CMW-KM5 Series, User Manual

Page: 552 / 856

LTE Multi Evaluation Measurement
R&S
®
CMW-KM5xx/-KS5xx
552 User Manual 1173.9628.02 ─ 16
Fig. 3-40: Measurement control settings - part 2
Network Signaled Value ..............................................................................................552
View Filter > NRB ........................................................................................................552
View Filter > Channel Type .........................................................................................553
RB Allocation ...............................................................................................................553
Physical Cell ID ........................................................................................................... 553
Delta Seq. Shift PUSCH ..............................................................................................553
Group Hopping ............................................................................................................554
Measurement Subframe ..............................................................................................554
Network Signaled Value
Adjust this value to the "network signaled value" used by the UE. The selected value
has impacts on the spectrum emission mask limit check, see
chapter 3.2.5.9, "Spec-
trum Emission Mask" , on page 515.
The available values depend on the configured carrier aggregation mode ("NS_xx" val-
ues or "CA_NS_xx" values).
In the Standalone (SA) scenario, this parameter is controlled by the measurement. In
the Combined Signal Path (CSP) scenario, it is controlled by the signaling application.
Remote command:
CONFigure:
​
LTE:
​
MEAS<i>:
​
MEValuation:
​
NSValue
​
(SA)
CONFigure:
​
LTE:
​
MEAS<i>:
​
MEValuation:
​
NSValue:
​
CAGGregation
​
(SA)
CONFigure:
​
LTE:
​
SIGN<i>:
​
CONNection:
​
ASEMission
​
(CSP)
View Filter > NRB
Specifies a number of allocated resource blocks (RBs) in the measured slot. Slots with
a different number of allocated blocks are rejected. Use this setting for signals with a
varying number of allocated RBs, if you wish to restrict the measurement to a subset of
slots with a specific number of RBs.
With carrier aggregation, the view filter is applied to the "Measurement Carrier".
GUI Reference
深圳德标仪器
135-1095-0799