LTE Multi Evaluation Measurement
R&S
®
CMW-KM5xx/-KS5xx
642
User Manual 1173.9628.02 ─ 16
CONFigure:LTE:MEAS<i>:MEValuation:LIMit:SEMask:LIMit<no>:
CBANdwidth<Band>
<Enable>, <FrequencyStart>, <FrequencyEnd>, <Level>,
<RBW>
Defines general requirements for the emission mask area <no>. The activation state,
the area borders, an upper limit and the resolution bandwidth must be specified.
The emission mask applies to the channel bandwidth <Band>.
Suffix:
<Band>
.
14,30,50,100,150,200
Channel bandwidth in 0.1 MHz
<no>
1..12
Number of emission mask area
Parameters:
<Enable>
OFF | ON
OFF
: disables the check of these requirements
ON
: enables the check of these requirements
*RST:
depends on channel bandwidth and area number
<FrequencyStart>
Start frequency of the area, relative to the edges of the channel
bandwidth
Range:
see table below
*RST:
depends on channel bandwidth and area number
Default unit: Hz
<FrequencyEnd>
Stop frequency of the area, relative to the edges of the channel
bandwidth
Range:
see table below
*RST:
depends on channel bandwidth and area number
Default unit: Hz
<Level>
Upper limit for the area
Range:
-256 dBm to 256 dBm
*RST:
depends on channel bandwidth and area number
Default unit: dBm
<RBW>
K030 | K100 | M1
Resolution bandwidth to be used for the area
K030
: 30 kHz
K100
: 100 kHz
M1
: 1 MHz
*RST:
K030 (<no> = 1) / M1 (<no> = 2 to 10)
Example:
See
Firmware/Software:
V1.0.10.1
V3.2.80: <no> of areas enhanced to 12
Command Reference
深圳德标仪器
135-1095-0799
