LTE Multi Evaluation Measurement
R&S
®
CMW-KM5xx/-KS5xx
553
User Manual 1173.9628.02 ─ 16
The allowed values for this parameter are restricted by 3GPP TS 36.211. For details
see
chapter 3.2.4.1, "Resources in Time and Frequency Domain"
Remote command:
View Filter > Channel Type
Allows to measure only slots for which the detected channel type equals Physical
Uplink Shared Channel (PUSCH) or only slots with channel type Physical Uplink Con-
trol Channel (PUCCH). The detected channel type is influenced by the parameters
and
With carrier aggregation, the view filter is applied to the "Measurement Carrier".
Remote command:
RB Allocation
If "Auto" is enabled, the RB configuration is detected automatically and the other set-
tings are ignored.
For manual definition of the RB configuration, disable "Auto". Enter the number of allo-
cated RBs in the measured slot (No RB) and the offset of the first allocated resource
block from the edge of the allocated UL transmission bandwidth (Offset RB).
With carrier aggregation, this setting applies to the "Measurement Carrier".
The allowed values for "No RB" are restricted by 3GPP TS 36.211. For details see
chapter 3.2.4.1, "Resources in Time and Frequency Domain"
Remote command:
Physical Cell ID
Adjust this parameter to the physical cell ID used by the measured LTE signal. This is
required to ensure that the R&S
CMW can synchronize to the signal and perform chan-
nel estimation.
In the Standalone (SA) scenario, this parameter is controlled by the measurement. In
the Combined Signal Path (CSP) scenario, it is controlled by the signaling application.
Remote command:
(SA)
(CSP)
Delta Seq. Shift PUSCH
Delta sequence shift value (Δ
ss
) used to calculate the sequence shift pattern for
PUSCH from the sequence shift pattern for PUCCH (refer to "group hopping" in 3GPP
TS 36.211). Adjust this value to the measured LTE signal to ensure that the R&S
CMW
can synchronize to the signal and perform channel estimation.
Remote command:
GUI Reference
135-1095-0799
