LTE Signaling
R&S
®
CMW-KM5xx/-KS5xx
85
User Manual 1173.9628.02 ─ 16
a) Press SIGNAL GEN.
The "Generator/Signaling Controller" dialog box opens.
b) Enable "LTE Signaling 1".
c) Press MEASURE.
The "Measurement Controller" dialog box opens.
d) Enable "Audio Measurements 1".
e) Enable "Data Appl. Measurement 1".
If this entry is not available, you can skip this step. The presence of the entry
depends on the presence of option R&S CMW-KM050.
The task bar at the bottom contains now hotkeys for access to the LTE signaling appli-
cation, the audio measurements and - optionally - to the data application measure-
ments. To show or hide the task bar, press TASKS.
Configuring and starting the IMS server
1. Open the "Data Application Control" dialog box.
a) Alternative 1, with R&S CMW-KM050:
On the task bar, press "Data Meas 1". The "Data Application Measurement"
view opens.
Press the "Configure Services" softkey.
b) Alternative 2, without R&S CMW-KM050:
Press SETUP. The "Setup" dialog box opens.
In the "System" section > "Data Appl. Control", press the "Go to config" button.
The "Data Application Control" dialog box opens.
2. Select the "IMS" tab.
3. Press the "Config" hotkey.
The IMS configuration dialog box opens.
4. Set "internal" > "Voice over IMS" > "Audio Routing" to "Audioboard"
5. Configure the remaining settings compatible to your UE:
● "Address Type"
Application Sheets
深圳德标仪器
135-1095-0799
