R&S CMW-KM5 Series, User Manual

Page: 564 / 856

LTE Multi Evaluation Measurement
R&S
®
CMW-KM5xx/-KS5xx
564 User Manual 1173.9628.02 ─ 16
Fig. 3-46: Limit settings with and without carrier aggregation
For limit configuration via remote commands, refer to the following sections:
●
chapter 3.5.3.10, "Limits (Modulation, QPSK)" , on page 630
●
chapter 3.5.3.11, "Limits (Modulation, 16-QAM / 64-QAM)" , on page 635
●
chapter 3.5.3.12, "Limits (Spectrum, no Carrier Aggregation)" , on page 640
●
chapter 3.5.3.13, "Limits (Spectrum, with Carrier Aggregation)" , on page 644
●
chapter 3.5.3.14, "Limits (Power)" , on page 653
3.3.8 Additional Softkeys and Hotkeys
The "LTE Multi Evaluation" measurement provides some softkey/hotkey combinations
which have no equivalent in the configuration dialog. Most of these hotkeys provide
display configurations (like diagram scaling). They are self-explanatory and do not
have any remote-control commands assigned.
The remaining softkeys > hotkeys are described below. The softkeys "Signaling
Parameter" and "LTE Signaling" are displayed only while the combined signal path
scenario is active and are provided by the "LTE Signaling" application selected as
master application. See also
"Scenario = Combined Signal Path" on page 540.
While one of the signaling softkeys is selected, the "Config" hotkey opens the configu-
ration dialog of the signaling application, not the configuration dialog of the measure-
ment.
GUI Reference
深圳德标仪器
135-1095-0799