PRÜFTECHNIK VIB 5.300 EX Series, Operating Instructions Manual

Page: 39 / 172

2-23
VIBXPERT 11.2010
Getting started - Basic settings
Dialog language
is changed to 'Deutsch' (German)
When a default sensor has been set up, the sensor can no longer be
specified in the measurement task manager. The corresponding
field is grayed out, although the sensor originally specified is still
visible (see also the figure on page 3-17).
Keyphaser
Here you can extend the time limit set for rpm measurements and
phase measurement to enable measurements on very low-speed
machines (range: 10 ... 30 s, default: 10s). The 'Active edge' option
is used to define whether the edge of the incoming trigger mark or
outgoing trigger mark on the shaft is to be used as the reference
signal.
Language
VIBXPERT includes 11 languages. The default setting is 'English'. To
change the language setting, proceed as follows:
• Click on 'Language'.
• Click on '
YourLanguage ' (e.g. Espanol , Francais ,...).
• Press MENU and click on 'OK'.
• Confirm the resulting message to restart the application (see below).
Communication
Settings for network communication, see page 2-34.
Registration
The functions and operating modes in VIBXPERT are distributed in
individual modules* that can be enabled by password as required.
VIBXPERT is supplied in the 'Basic' version with which overall values
as well as (limited) spectra can be measured. For example, to enable
the standard 1-channel version, the 'VIBXPERT firmware for 1

Note
*The attachment on page 6-22
contains an overview of the modules
and the available measurement
functions.
Device Setup
Device Setup
Device Setup