PRÜFTECHNIK VIB 5.300 EX Series, Operating Instructions Manual

Page: 116 / 172

4-22
VIBXPERT 11.2010
Printing
Printing out the report for route/machine template
You can print out the following measurements as reports to docu-
ment the results in a route/machine template:
A
LL OVERALL VALUES
, T
REND PARAMETERS FROM
T
RENDING
S
PECTRUM
,
V
ISUAL INSPECTION
, A
LL PHASE MEASUREMENTS
In addition to a table of results, the report contains general
information and additional data on the measurement. Threshold
values are automatically added if they are exceeded during measure-
ment.
• Open the route/template.
• In the tree view, mark the entry for which you wish to create the
report.
The results of all measurement locations located below this entry
in the hierarchy are printed out.
• Press the MENU key and click on 'Print'. The report configuration
appears.
• If necessary, change the report configuration.
The settings in the 'Common settings' tab are the same as the
settings for the measurement reports (see previous page). The
following detailed data can be set in the 'Measure info' tab.
U
NMEASURED JOBS
: Measurement tasks that have not been measured are
included in the report.
RPM: The speed is printed out if available.
C
APTION
: A legend is output as an appendix to the report.
O
VERALL VALUE
: Selection of the vibration values
T
ABLE ORIENTATION
: Arrangement of the measurement tasks in the table
( horizontal/vertical ).
P
APER ORIENTATION
: Paper orientation selectable between portrait or
landscape.
Start the printout as described under 'Printing out the measurement
report' (see previous page).
Configuration for route report
Specific data