When an error message is displayed (Error code list)
Maintenance/Troubleshooting
1-154
Errors displayed with the LT3000 series
I/O driver errors
• When the STD driver is used:
Any of the following error messages appears depending on the result of the I/O moni-
toring of the module connected to the STD driver. When an error message appears
online, an error code of [RGEE
∗∗∗
] (Any of the error numbers described below is
stored to
∗∗∗
.) and the corresponding error message appear in the system menu.
Error No.
Error Message
Cause and Solution
001
Invalid module type
The specified module type is not supported.
The project file may not have been transferred
successfully. Transfer the project file again.
002
Invalid value
The type of the variable assigned to the termi-
nal is invalid, or the terminal setting is invalid.
The project file may not have been transferred
successfully. Transfer the project file again.
003
Out of device range
The variable address assigned to the terminal is
invalid. The project file may not have been trans-
ferred successfully. Transfer the project file again.
004
Too many term. setting
The number of terminals is invalid. (The num-
ber of terminals is excessive.) The project file
may not have been transferred successfully.
Transfer the project file again.
005
Invalid terminal order
The terminal numbers are not arranged in
ascending order. The project file may not have
been transferred successfully. Transfer the
project file again.
006
Not enough terminals
The number of terminals is invalid. (The num-
ber of terminals is insufficient.) The project file
may not have been transferred successfully.
Transfer the project file again.
007
Repeat module settings
Module registration is duplicated. The project
file may not have been transferred successfully.
Transfer the project file again.
008
Too many mod. settings
The number of modules is invalid. (The num-
ber of terminals is excessive.) The project file
may not have been transferred successfully.
Transfer the project file again.
009
Repeat driver settings
Driver registration is duplicated. The project
file may not have been transferred successfully.
Transfer the project file again.
010
I/O setting mismatch
The terminal setting is invalid. (The I/O setting
in the module does not match.) The project file
may not have been transferred successfully.
Transfer the project file again.
Continued
