Playnation Everest Extreme 1500MW, Instruction Manual

Page: 72 / 234

STEP 1: ATTACHING T-NUTS TO THE CORNER POSTS
1: THIS STEP IS CRITICAL TO BUILDING THE FORT PROPERLY. IF ANY MISTAKES ARE MADE HERE, YOU WILL NEED TO
DIS-ASSEMBLE AND THEN RE-ASSEMBLE TO MAKE YOUR CORRECTIONS.
2: MAKE SURE HOLES ARE FREE OF ANY OBSTRUCTIONS. USE A BOLT TO CLEAN OUT ANY DEBRIS.
3: LAY OUT EACH OF THE 4 X 4 X 108" CORNER POSTS AND 4 X 4 X 120" MIDDLE CORNER POST IN THE AREA YOU
INTEND ON BUILDING THE FORT SIDE OF THE PLAYSET.
4: USE THE DIAGRAM BELOW TO CORRECTLY IDENTIFY AND ORIENT THE NECESSARY DIRECTION THE POSTS
SHOULD FACE.
5: USE A HAMMER TO SEAT THE T-NUTS AFTER INSERTING THEM INTO THE HOLES SHOWN IN THE DIAGRAM BELOW.
6: THE BARREL OF THE T-NUT SHOULD GO IN THE HOLE FIRST. HAMMER THE T-NUT UNTIL IT IS FLUSH/ALMOST FLUSH TO
THE CORNER POSTS.
CORNER
POSTS
THESE HOLES.
NO T-NUT IN
THE FRONT
POSTS DO
4 X 4 X 120"
MIDDLE
CORNER
LEFT SIDE OF FORT
POSTS SHOULD BE FACING THIS DIRECTION.
HOLES AT THE TOP OF THE CORNER
CARRIAGE BOLTS.)
BEAM MOUNT USING
4 X 4 X 120"
HERE THAT
MIDDLE
CORNER
POST
POST
NOT HAVE.
POSTS DO
THE FRONT
4 X 4 X 108"
EXTRA HOLE
HAVE AN
NOT HAVE
POST.
FRONT CORNER
HOLES (FOR SWING
MIDDLE
NO T-NUT IN THESE
FRONT OF FORT
MIDDLE
CORNER
POSTS
HAVE AN
EXTRA HOLE
HERE THAT
RIGHT
SIDE OF
FORT
62