Playnation Everest Extreme 1500MW, Instruction Manual

Page: 158 / 234

UNFINISHED END
(TRIMMED END)
ROOF FINISHER
FLUSH
#8 X 1-1/4" WOOD SCREW
ROOF BATTEN
(TOP SECTION)
CUT THIS SIDE
BOTTOM END
2 "
1
2
22 12 "
32"
2 12 "
1 X 2 X 32" ROOF BATTEN
ALONG THE BATTEN.
ROOF FINISHER. INSERT 1-1/4" WOOD SCREWS THROUGH THE PRE-DRILLED HOLES
ALONG THE BATTEN.
CUT THE TOP SECTION OF THE ROOF BATTEN. FOLLOW THE DIRECTIONS IN THE DIAGRAM BELOW FOR PROPER
THE BOTTOM END 22-1/2" TO THE TOP, MAKE A MARK WITH A PENCIL. USING A HAND SAW OR AN ELECTRIC SAW,
MEASURING.
2: THE REMAINING 1 X 2 X 32" ROOF BATTEN WILL BE CUT TO FIT THE REAR ROOF PANEL SECTION. MEASURE FROM
SHORTENED ROOF BATTEN
1: PLACE THE 1 X 2 X 32" ROOF BATTEN UP AGAINST THE FRONT ROOF PANEL, CENTERED BETWEEN THE ROOF
SUPPORTS, FLUSH THE BOTTOM EDGE OF THE ROOF BATTEN TO THE BOTTOM EDGE OF THE SEVENTH ROOF BOARD,
MAKE SURE IS PARALLEL TO THE ROOF SUPPORTS. INSERT 1-1/4" WOOD SCREWS THROUGH THE PRE-DRILLED HOLES
3: ONCE THE ROOF BATTEN HAS BEEN CUT TO 22-1/2", PLACE IT AGAINST THE REAR
ROOF PANEL. THE UNFINISHED END (TOP END) MUST BE POINTING TOWARDS THE
ROOF PEAK, AND THE BOTTOM END MUST BE FLUSH TO THE BOTTOM EDGE OF THE
STEP 84: ROOF BATTEN
148