WARNING
Insufficiently qualified personnel are unable to correctly assess risks posed
when working with the milling unit. These persons may therefore put
themselves and others at risk of serious and even fatal injuries.
In order to avoid this, persons with inadequate qualifications are prohibited
from carrying out work on the milling unit. New users must receive milling
unit training before using the milling unit for the first time.
7.2.1 Qualifications
Work on and with the milling unit must be carried out exclusively by
authorised, trained and instructed personnel. Such personnel must receive
instructions regarding possible hazards and special residual risks that may
arise.
The qualifications required for the various tasks are listed below:
User
The user is the person who uses the milling unit for commercial or industrial
purposes, or who commissions a third party with this, and who bears the
legal product responsibility for protecting third parties during its operation.
The milling unit user is subject to the statutory obligations of industrial health
and safety when using the milling unit in commercial areas.
The user and the personnel authorised by the user (who receive special
instructions regarding hazards that may arise) are responsible for the
faultfree operation of the milling unit, and for clear stipulations regarding
the responsibilities when transporting, installing, operating, maintaining and
cleaning the milling unit.
In addition to the safety instructions and information in this user’s manual,
it is also necessary to observe and adhere to the local accident prevention
regulations and the general health and safety provisions, as well as the valid
environmental protection regulations relevant to the area of use of the milling
unit.
Electrician
A qualified electrician is able to independently perform work on electrical
systems and detect and avoid possible dangers due to their professional
training, skills and experience, as well as their knowledge of the applicable
standards and provisions.
A qualified electrician is familiar with all the relevant standards and
provisions applicable to their working environment.
Specialist personnel
Qualified personnel are able to independently detect and avoid possible
dangers and hazards due to their professional training, skills and
experience.
Manufacturer (service technician)
The manufacturer's specialist personnel are authorised to perform certain
work exclusively. In order to carry out this work, contact your local Planmeca
dealer.
7.3 Safety instructions for operation
For safe handling of the machine, note the following points:
7 For your safety
12 Planmeca PlanMill 60 S
User's manual
