Perkins 1300 EDi Series, Workshop Manual, Page: 230 / 264

15
218 Workshop Manual, TPD 1353E, Issue 3
Peregrine EDi and 1300 Series EDi
Power take-off adaptor
To remove and to fit Operation 15-3
To remove
1 Remove the power steering pump, see Operation 15-2.
2 Release the setscrews and remove the power take-off (PTO) adaptor. Discard the joint.
To fit
1 Fit a new joint to the adaptor and lubricate the joint with clean engine lubricating oil.
2 Fit the drive gear into the end of the compressor output flange, or into the timing case if a compressor is not
fitted. Push the pump fully into position.
3 Fit and tighten the setscrews.
4 Fit the power steering pump, see Operation 15-2.
To tighten the drive gear nut Operation 15-4
1 Press the drive gear (A1) of the PTO adaptor into the bearings in the housing (A2) of the PTO adaptor.
2 Fit the lock plate (A4) to the shaft of the drive gear.
3 Fit and tighten the nut (A3) until the end-float of the drive gear is eliminated.
4 Release the nut
1
/
24
of a turn (15° to 20°) to give an end-float of 0,025/0,076 mm (0.001/0.003 in). Rotate
the nut until the nearest tag on the lock plate aligns with a slot (A5) in the nut.
5 Bend the tag until it fits into the slot to lock the nut in position.
W243
A
1 2
3
4
5
This document has been printed from SPI². Not for Resale