Perkins 1300 EDi Series, Workshop Manual, Page: 185 / 264

11
Workshop Manual, TPD 1353E, Issue 3 173
Peregrine EDi and 1300 Series EDi
Fuel lift pump
To remove and to fit Operation 11-5
To remove
Note: The fuel lift pump is fitted to the side of the high-pressure pump.
1 Remove the banjo bolts (A1 and A5) from the fuel pipes and discard the washers (A2 and A4).
2 Release the nuts (A3) and remove the pump (A6).
3 Remove and discard the joint.
To fit
1 Clean the joint face on the fuel lift pump and on the high-pressure pump.
Note: Ensure that the eccentric on the camshaft of the high-pressure pump is in the minimum lift position. If it
is not, rotate the crankshaft until it is.
2 Fit a new joint to the lift pump.
3 Check that the push rod (Operation 11-6/A12) is in position and fit the lift pump to the high-pressure pump.
4 Fit and tighten the nuts (A3) gradually and evenly to 6 Nm (4 lbf ft) 0,6 kgf m.
5 Connect the fuel pipes to the fuel lift pump, fit new copper washers (A2 and A4) to the banjo bolts (A1 and
A5). Tighten the banjo bolts to 35 Nm (26 lbf ft) 3,6 kgf m.
W129/1
A
1
2
3
4
5
6
This document has been printed from SPI². Not for Resale