Perkins 1300 EDi Series, Workshop Manual, Page: 81 / 264

5
Workshop Manual, TPD 1353E, Issue 3 69
Peregrine EDi and 1300 Series EDi
Rear oil seal housing assembly
To remove the oil seal housing Operation 5-4
Cautions:
l
Renew the rear oil seal and the wear sleeve as a unit, do not separate them.
l
The flywheel housing does not have to be removed to renew the rear oil seal.
1 Drain the lubricating oil.
2 Remove the lubricating oil sump, see Operation 10-9.
3 Remove the drive components from the rear end of the engine.
4 Remove the flywheel, see Operation 13-1.
5 Remove the rear oil seal, see Operation 5-6.
6 Remove the four setscrews that pass through the flange of the sump and into the bottom of the seal housing.
7 Remove the six setscrews that retain the seal housing to the cylinder block.
8 Remove the rear oil seal and housing assembly (A). Remove and discard the old oil seal gasket from
between the housing and the cylinder block.
9 Hit carefully the outside diameter of the wear sleeve with a hammer to loosen the wear sleeve from the
crankshaft (B).
10 Remove the wear sleeve from the crankshaft.
W045
A
W091
B
This document has been printed from SPI². Not for Resale