Perkins 1300 EDi Series, Workshop Manual, Page: 166 / 264

10
154 Workshop Manual, TPD 1353E, Issue 3
Peregrine EDi and 1300 Series EDi
To fit Operation 10-22
1 Fit a new joint to the pump.
2 Align the drive gear to mesh with the lower idler gear, push the pump into the rear of the timing case. Fit and
tighten the two setscrews (A1) to 27 Nm (20 lbf ft) 4,8 kgf m.
3 Fit the sensor (C1) for engine oil temperature and connect its electrical cable (C2).
4 Fit the solenoid (B5) of the regulator valve. Fit and tighten its nut (B6) to 6 Nm (4.5 lbf ft) 0,6 kgf m. Connect
its electrical cable (C4).
5 Connect the fuel pipes to the fuel lift pump, fit new copper washers to the banjo bolts (B2 and B4). Tighten
the banjo bolts to 35 Nm (26 lbf ft) 3,6 kgf m.
6 Fit the high-pressure oil pipe (B3).
W232
A
1
W229
C
1
2
3
4
W230
B
1
2
3
4
5
6
This document has been printed from SPI². Not for Resale