Perkins 1300 EDi Series, Workshop Manual, Page: 164 / 264

10
152 Workshop Manual, TPD 1353E, Issue 3
Peregrine EDi and 1300 Series EDi
Sensor for injection control pressure
To remove and to fit Operation 10-20
To remove
1 Disconnect the electrical cable at the sensor for injection control pressure.
2 Remove the sensor for the supply manifold and discard its ‘O’ ring.
To fit
1 Fit a new ‘O’ ring to the sensor.
2 Apply Loctite 277 to the threads of the sensor.
3 Fit and tighten the sensor to 26 Nm (19 lbf ft) 2,6 kgf m.
This document has been printed from SPI². Not for Resale