Perkins 1300 EDi Series, Workshop Manual, Page: 254 / 264

17
242 Workshop Manual, TPD 1353E, Issue 3
Peregrine EDi and 1300 Series EDi
13 Press
14 Move each electrical cable and connector up and down and from side to side to test for faulty connections.
l
If a fault occurs, a sound will be heard and the tool display will alter to show “BEEP” and “NEW CODES 1”.
Press
e.g.
l
When all the cables and connections have been tested, and corrected if necessary, press
15 Press
“OUTPUT STATE TEST”
16 Move through the program until “OUTPUT STATE TEST” shows on the display, see Operation 17-4.
17 Press
l
If there are no faults:
l
If there are faults:
18 Press e.g.
19 If the arrows show, press to obtain the other codes.
Continued
ENTER
NEW CODES 0
ENTER
ENGINE OIL TEMP
SIGNAL HIGH
CODE: 312
ENTER
TEST COMPLETED
0 NEW CODES FOUND
[CONTINUE] CANCEL
ENTER
ENGINE OFF TESTS
- - - - - - - - - - - selections- - - - - - - - - -
OUTPUT STATE TEST
ENTER
OUTPUTS LOW
NEW CODES 0
OUTPUTS LOW
NEW CODES n
ENTER
ENGINE OIL TEMP
SIGNAL LOW
CODE: 312
This document has been printed from SPI². Not for Resale