Perkins 1300 EDi Series, Workshop Manual, Page: 82 / 264

5
70 Workshop Manual, TPD 1353E, Issue 3
Peregrine EDi and 1300 Series EDi
To fit the oil seal housing Operation 5-5
Special requirements
1 Clean the faces of the cylinder block, the oil seal housing and the crankshaft palm.
2 Fit the guide adaptor from tool 21825963 to the end of the crankshaft (A).
3 Fit a new seal (B1) to the oil seal housing face (B3).
4 Put the housing (B2) into position on the engine, fit and tighten the setscrews finger tight.
5 Fit the plate from tool 21825963 to the guide adaptor. Tighten the nut of the tool (C) until the plate comes
into contact with the face of the housing.
6 Use a straight edge to check that the seal housing is level with the cylinder block face (D).
7 Tighten the setscrews to 24 Nm (18 lbf ft) 2,5 kgf m.
Continued
Special tools
Description Part number
Rear oil seal installer 21825963
W092/1
A
W093
B
1
2
3
W046
D
W048/1
C
This document has been printed from SPI². Not for Resale