Perkins 1300 EDi Series, Workshop Manual, Page: 80 / 264

5
68 Workshop Manual, TPD 1353E, Issue 3
Peregrine EDi and 1300 Series EDi
To inspect Operation 5-3
Clean the components and check for damage.
The assembly must be renewed if:
l
There are cracks in the rubber (A2)
l
The rubber is damaged by oil
l
The component alignment marks (A1) exceed the tolerance in the relevant Data and dimensions for the
"Crankshaft assembly" on page 14.
Measure and record damper alignment (B) at four places (B1) 90° apart on the damper face. Ensure that the
crankshaft is at the same end of its axial movement for each measurement. This eliminates crankshaft end-
float from the measurement.
Before the pulley / damper assembly is removed from the crankshaft, measure and record the run-out of the
damper mounting face on the crankshaft palm.
Compare all the readings with the relevant Data and dimensions for the "Crankshaft assembly" on page 14.
W020
A
1
2
W021
B
1
This document has been printed from SPI². Not for Resale