Perkins 1300 EDi Series, Workshop Manual, Page: 141 / 264

10
Workshop Manual, TPD 1353E, Issue 3 129
Peregrine EDi and 1300 Series EDi
Filter canister
To renew the canister of the lubricating oil filter Operation 10-1
Warning! Discard the used canister and lubricating oil in a safe place and in accordance with local regulations.
Caution: Ensure that the application is on a level surface to ensure an accurate reading on the dipstick.
1 Operate the engine before the oil filter is removed. This ensures that oil is in the bearing housing of the
turbocharger.
2 Put a tray under the filter to retain lubricating oil.
3 Clean thoroughly the outer surfaces of the filter assembly.
4 Use a strap wrench or similar tool to loosen the filter canister, remove and discard the canister. Ensure that
the adaptor (A1) is secure in the filter head.
Warning! Discard the used canister and lubricating oil in a safe place and in accordance with local regulations.
5 Clean inside the filter head.
6 Lubricate the seal (A2) on top of the new canister with clean engine lubricating oil.
7 Fit the new canister and tighten by hand until the seal contacts the filter head. Tighten the canister a further
1
/
2
to
3
/
4
of a turn by hand. Do not use a strap wrench.
8 Ensure that there is lubricating oil in the sump.
Continued
W014
A
2
1
This document has been printed from SPI². Not for Resale