Perkins 1300 EDi Series, Workshop Manual, Page: 138 / 264

9
126 Workshop Manual, TPD 1353E, Issue 3
Peregrine EDi and 1300 Series EDi
List of possible causes
1 Element of the air filter dirty
2 Restricted crankcase breather
3 Element of the air filter missing, leaking or not sealing correctly. Loose connection to turbocharger.
4 Internal distortion or restriction in pipe from air filter to turbocharger.
5 Damaged / restricted crossover pipe, turbocharger to induction manifold.
6 Restriction between air filter and turbocharger.
7 Restriction in exhaust system.
8 Turbocharger loose or clamps / setscrews loose.
9 Induction manifold cracked or loose, flanges distorted.
10 Exhaust manifold cracked or loose, flanges distorted.
11 Restricted exhaust system.
12 Delay of lubricating oil to turbocharger at engine start.
13 Insufficient lubrication.
14 Dirty lubricating oil.
15 Incorrect lubricating oil.
16 Restricted lubricating oil supply pipe.
17 Restricted lubricating oil drain pipe.
18 Turbine housing damaged or restricted.
19 Leakage from turbocharger seals.
20 Worn turbocharger bearings.
21 Excessive dirt in compressor housing.
22 Excessive carbon behind turbine rotor.
23 Engine speed raised too rapidly at initial start.
24 Insufficient engine idle period.
25 Faulty fuel injection pump.
26 Worn or damaged atomisers.
27 Valves burned.
28 Worn piston rings.
29 Lubricating oil leakage from supply pipe.
30 Excessive preservation fluid (on initial engine start).
31 Excessive engine idle period.
32 Restriction in turbocharger bearing housing.
33 Restriction in lubricating oil filter.
34 Wet type air cleaner: Restricted, dirty element, viscosity of oil too low / high.
35 Waste-gate actuator faulty or damaged.
36 Waste-gate valve not free.
37 Engine stopped too soon from high load.
38 Insufficient lubricating oil.
39 Fuel leakage from fuelled starting aid.
40 Crack in backplate of compressor.
This document has been printed from SPI². Not for Resale