Perkins 1300 EDi Series, Workshop Manual, Page: 229 / 264

15
Workshop Manual, TPD 1353E, Issue 3 217
Peregrine EDi and 1300 Series EDi
Power steering pump
To remove and to fit Operation 15-2
To remove
1 Disconnect the connections at the power steering pump and fit covers to the open connectors.
2 Release the setscrews and remove the pump. Discard the ‘O’ ring.
To fit
1 Fit a new ‘O’ ring and lubricate it with clean engine lubricating oil.
2 Fit the drive shaft into the end of the compressor output flange and push the pump fully into position.
3 Fit and tighten the setscrews.
4 Remove the covers from the connectors and fit the connections.
5 Check, and if necessary replenish, the power steering fluid to the correct level.
This document has been printed from SPI². Not for Resale