Paradyne ACCULINK 316x, Operator'S Manual

Page: 87 / 211

Operation
3-45 3160-A2-GB22-10 December 1996
4. The Start At screen displays the configuration
option used to select the starting DS0 channel. If
the destination selected is the Network T1
interface, then the Network channels appear on the
screen. If the destination selected is the DSX-1
DS-1 Drop/Insert T1 interface, then these channels
appear on the screen. The following screen shows
an example of the Network T1 interface. Use the
or key to scroll the desired channel onto
the screen. Use the Function keys to select the
starting channel. Only those DS0 channel numbers
that provide enough bandwidth (based on the
configured data rate) to be used as a starting
channel number are displayed.
F1
Start At:Clear
Next
Clear N1
F2 F3
Individual Channel Assignment Method
Example
The Assign By configuration option screen appears
after you select a port. To assign by the individual channel
method,
1. Press the key once to bring the Chan selection
onto the screen.
F1
Assign By:Block
Next Block ACAMI
F2 F3
2. Press F3 (Chan).
F1
Assign By:Chan
Block
ACAMI Chan
F2 F3
3. Press F1 (Next) to display the next configuration
option (channel allocation).
F1
Assign By:Chan
Next Block ACAMI
F2 F3
4. Line 1 displays the 24 channels for the Network
T1 interface or the DSX-1 Drop/Insert T1
interface, depending on which destination was
chosen. This example assumes that the Network
T1 interface is the destination. Line 2 displays
what is allocated to the DS0 channel shown in
Line 1. Pressing the
or key scrolls the
channels onto the screen in groups of three.
Possible values for Line 2 are listed in Table 3-7.
Select the channel by pressing the Function key
under the desired number. Portn appears. The port
is assigned to that channel. To unallocate a port,
press the Function key under that port number.
Pressing the Function key under channels assigned
to other ports has no effect.
F1
N1 N2
Next Prt1 Prt2
F2
F3
Allocating DS0 Channels from the DSX-1
Drop/Insert T1 Interface to the Network T1
Interface
You can allocate DS0 channels from the DSX-1
Drop/Insert T1 interface to the Network interface and
specify which DS0 channels carry Robbed Bit
Signaling (RBS) information for voice channels.
To allocate DS0 channels from the DSX-1 Drop/Insert
T1 interface to the Network interface,
1. Press F3 to select Cnfig from the top-level menu
screen.
F1 F2
F3
DSU ESF
Stat
Test Cnfig