Paradyne ACCULINK 316x, Operator'S Manual

Page: 86 / 211

ACCULINK 316x DSU/CSU
3-44 December 1996 3160-A2-GB22-10
3. Use the or key to scroll the desired port
rate onto the screen. Rates scroll in groups of
three. Available selections depend on the current
base rate selected for the port. Press the
corresponding Function key to select the port rate.
Then, select Next to display the Start At
configuration option on the screen.
F1
Port Rate:384
Next
64 128
F2
F3
NOTE
For the 3164 DSU/CSU, there is a
hardware limitation that limits the
combined bandwidth used by
Port1 and Port3 to a total of
2048 kbps, and the combined
bandwidth used by Port2 and
Port4 to 2048 kbps. Thus, the rate
choices shall be limited
appropriately due to this
constraint. This limitation should
only occur in configurations
mapping a port to a port or when
mapping ports to the DSX-1 and
to the network.
4. The Start At screen displays the configuration
option used to select the starting DS0 channel. If
the destination selected is the Network T1
interface, then the Network channels appear on the
screen. If the destination selected is the DSX-1
DSX-1 Drop/Insert T1 interface, then the these
channels appear on the screen. The following
screen shows an example of the Network T1
interface. Use the
or key to scroll the
desired channel onto the screen. Use the Function
keys to select the starting channel. Only those DS0
channel numbers that provide enough bandwidth
(based on the configured data rate) to be used as a
starting channel number are displayed. Channel
allocation for this port only can be cleared by
selecting Clear.
F1
Start At:Clear
Next
Clear N1
F2 F3
ACAMI Channel Assignment Method Example
The Assign By configuration option screen appears
after you select a port. To assign by the ACAMI method,
1. Press F3 (ACAMI).
F1
Assign By:Block
Next Block ACAMI
F2 F3
2. Press F1 (Next) to display the next configuration
option (Port Rate).
F1
Assign By:ACAMI
Next Block ACAMI
F2 F3
3. Use the or key to scroll the desired port
rate onto the screen. Rates scroll in groups of
three. Available selections depend on the current
base rate selected for the port. Press the
corresponding Function key to select the port rate.
Then, select Next to display the Start At
configuration option on the screen.
F1
Port Rate:384
Next
64 128
F2 F3