−
27
−
CN SER and CN NET Connectors (For PC or Controller)
・ These connectors can be used as either RS232C or RS485. There are three
ways for using these connectors as shown below.
For RS232C communication only
Connect the personal computer and the driver 1:1 through RS-232C,The
PANATERM using for communication control softwere. The PANATERM using this
function the monitor of the personal computre settings wave graphics.
For both RS232C and RS485 communication
You connect the host and the 1st driver with RS232C, and connect the drivers
in series with RS485.
For RS485 communication only
Connect all the drivers and a host with RS485.
・ Rotary switch (ID): select a position 1 to F.
< Note >
・ Max. 15 drivers can be connected to a host.
・ For detailed information, see Communication Specifications.
ID
MODE
IM
I/F
SP
G
SET
ロータリスイッチ(ID)は1(出荷設定)でご使用ください。
How to connect
Special
cable (optional)
CN SER
Turn off the power of both the
driver and computer, before
connecting or disconnecting
the connectors.
Tighten the screws firmly.
RS232C connector
(rear)
ID
MODE
IM
I/F
SP
G
SET
ID
MODE
IM
I/F
SP
G
SET
ID
MODE
IM
I/F
SP
G
SET
ロータリスイッチ(ID)を1〜Fに設定してください。
ロータリスイッチ(ID)
は0に設定する。
RS485
RS485
RS232C
Host (personal computer
or controller)
RS485 connector
(CN NET)
232C/485 connector
(CN SER)
Preparations and Adjustments
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com