Overland Storage LoaderXpress, User & Installation Manual

Page: 96 / 104

5-18 Troubleshooting
U
SING THE
D
EMO
S
UBMENU
*If you do not know the unlock code, contact your system administrator.
If an error message displays that is not included in this table, write down the fault code
number and follow the recovery procedure described on line 4 of the display. If the same
error occurs again, call your Technical Support Representative.
Using the Demo Submenu
CAUTION: Caution: Do Not Run this library robotics excercise with cleaning cartridges in any of the
slots, including the reserved slots. Remove all cleaning cartridges from the magazine before starting
this excercise.
This option allows you to fully exercise the library robotics.
1) From the Maintenance Menu, select the Demo Submenu.
2) Select Demo 1.
The library robotics begin to move cartridges randomly from slot to slot, displaying the
number of passes on the screen.
If all slots in the magazine are full, Demo 1 loads a cartridge into the SDLT drive and
leaves it there. If you press the
button while Demo 1 is running, the LibraryXpress loads
a cartridge into the SDLT drive, unless it is full. If you press the button again, the
cartridge is unloaded from SDLT drive and returned to the magazine.
Demo 1 runs continuously as long as the LibraryXpress has power.
F007 Flash Invld SCSI Cmd
Press Enter to Clear SOFT fault - the transfer length requested in a SCSI
Write Buffer command was greater than 0x8000 bytes. F
F010 Flash Erase Error
Enter to Reboot or
Power Down to Clear HARD fault - the EEPROM failed to properly erase 1 or
more sectors during the reprogram cycle. C, D, G
F011 Flash Download Error
Enter to Reboot or
Power Down to Clear HARD fault - the sector data download was
incomplete after 5 seconds or the sector data had a
CRC err after 5 download attempts. C, D, G
F012 Flash Program Error
Enter to Reboot or
Power Down to Clear HARD fault - an EEPROM sector did not program
properly. C, D, G
F013 Flash CRC Error
Enter to Reboot or
Power Down to Clear HARD fault - the CRC of the newly programmed
image was incorrect. C, D, G
F013 Flash Boot CRC Error
Enter to Reboot or
Power Down to Clear HARD fault - the CRC of the boot code image is bad. C, D, G
Table 0–1 Fault Symptom Codes