Installation
2-19
H
OST
C
OMPUTER
C
ONNECTION
Figure 2–28 Interface Connections
Single Host configuration depicted below:
•
Each end of twisted pair ground must be connected to chassis ground
•
When calculating the overall length of the bus, be sure to include the internal
cabling of the module, which is 27 inches (69 cm.) for all models
•
Cables of different impedance should not be used together
*For additional specifications, refer to ANSI X3.131-1994 or later.
NOTE:
This equipment has been tested for electromagnetic emissions and immunity
using good quality shielded cables. If you use poor quality or unshielded cables,
they may not comply with national and international conformities.
Host Computer Connection
1) Verify that the following hardware/software are available:
a.Drives and the controller (library) are daisy-chained together
b.The host system has a compatible SCSI controller and the appropriate driver
software installed. (If you have questions about installation for specific host
systems, call your Technical Support representative.)
c.The cables you are using meet the required specifications for type and length
d.The terminator type matches your system.
5) If the Loader is the only SCSI device you are connecting to the host, do the
following:
a.Connect the cable from the host to one of the SCSI connectors
b.Attach the terminator to the outgoing SCSI connector
MODEL XXX-LXL-XXXXXX
P/N 000000-001/E
SERIAL NO 2B00174316
RATING
CAUTION
XXXXXXXXXXXXXXXXXXX
XXXXXXXXXXXXXXXXXXX
XXXXXXXXXXXXXXXX
This device complies with Part 15 of FCC rules Operation is
xxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxx
xxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxx
xxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxx
C
L
U
R
US
TUV
PRODUCT S ERVICES
S
G
xxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxx
xxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxx
xxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxx
XX XXX XX XXX XX XX XXX XX XXX XX XXX XX XXX XX XXX XX XX XXX XX XXX XX XXX XX XXX XX XX XXX XX
XX XXX XX XXX XX XX XXX XX XXX XX XXX XX XXX XX XXX XX XX XXX XX XXX XX XXX XX XXX XX XX XXX XX
XX XXX XX XXX XX XX XXX XX XXX XX XXX XX XXX XX XXX XX XX XXX XX XXX XX XXX XX XXX XX XX XXX X
INFORMATION TECHNOLOGY E QUIPME NT
SCSI
TERMINATOR
SCSI
CONNECTOR
FLASH
CONNECTOR
POWER
CONNECTOR
MODEL XXX-LXM-XXXXXX
P/N 000000-001/E
SERIAL NO 2B00174316
RATING
CAUTION
XXXXXXXXXXXXXXXXXXX
XXXXXXXXXXXXXXXXXXX
XXXXXXXXXXXXXXXX
This dev ice co mp lie s with Part 15 o f FC C ru les Op era tion is
xxxx xxxxxxxx xxxxxxxx xxxxxxx xxxxxxxx xxxxxxxx xxxxxxxx xxxxxxx xxxxxxxx xx
xxxx xxxxxxxx xxxxxxxx xxxxxxx xxxxxxxx xxxxxxxx xxxxxxxx xxxxxxx xxxxxxxx xx
xxxx xxxxxxxx xxxxxxxx xxxxxxx xxxxxxxx xxxxxxxx xxxxxxxx xxxxxxx xxxxxxxx xx
C
L
U
R
US
TUV
P RO D U C T S ER V IC E S
S
G
xxxx xxxxxxxx xxxxxxxx xxxxxxx xxxxxxxx xxxxxxxx xxxxxxxx xxxxxxx xxxxxxxx xx
xxxx xxxxxxxx xxxxxxxx xxxxxxx xxxxxxxx xxxxxxxx xxxxxxxx xxxxxxx xxxxxxxx xx
xxxx xxxxxxxx xxxxxxxx xxxxxxx xxxxxxxx xxxxxxxx xxxxxxxx xxxxxxx xxxxxxxx x
X XX X XX XX X XX X XX X XX X XX XX X XX X XX X XX X XX XX X XX X XX X XX X XX XX X XX X XX X XX X XX XX X XX X
X XX X XX XX X XX X XX X XX X XX XX X XX X XX X XX X XX XX X XX X XX X XX X XX XX X XX X XX X XX X XX XX X XX X
X XX X XX XX X XX X XX X XX X XX XX X XX X XX X XX X XX XX X XX X XX X XX X XX XX X XX X XX X XX X XX XX X XX
Summary of Contents for LoaderXpress
