Overland Storage LoaderXpress, User & Installation Manual

Page: 95 / 104

Troubleshooting 5-17
F
AULT
S
YMPTOM
C
ODES
(FSC)
B001 Boot ROM CRC Error
Power Down to Clear HARD fault - The CRC of the boot sector is bad. The
boot sector image is unusable. C, D, G
B002 Boot RAM Test Failed
Power Down to Clear HARD fault - The RAM did not return the expected
data on a write/read test. C, D, G
B004 Boot Comm Open Error
Power Down to Clear HARD fault - The boot code was unable to open the
serial trace port. Either the baud rate loopback test
failed or one of the "expected 0" bit tests failed. C, D, G
B005 Boot Novram Error
Power Down to Clear HARD fault - The novram checksum did not match the
novram data. C, D, G
B006 Boot Unused Int.
Power Down to Clear HARD fault - An unused interrupt vector was executed
due to code or hardware failure. C, D, G
B007 Flash Init. Error
Power Down to Clear HARD fault - The boot code was unable to correctly
update the flash code image. C, D, G
B010 Boot UART 0 Error
Power Down to Clear HARD fault - The boot code was unable to open the
serial trace port. C, D, G
B011 Boot UART 1 Error
Power Down to Clear HARD fault -The boot code was unable to open the
LTO drive serial port. C, D, G
B012 Boot UART 2 Error
Power Down to Clear HARD fault - The boot code was unable to open the
barcode serial port. C, D, G
B013 Boot UART 3 Error
Power Down to Clear HARD fault - The boot code was unable to open the
Web TLC serial port. C, D, G
B014 Boot UART 4 Error
Power Down to Clear HARD fault - unused in LTO. C, D, G
F001 No Flash Installed
Press Enter to Clear SOFT fault - A flash update operation was aborted
because the PWB was built with a ROM instead of an
EEPROM. F
F002 Invalid Comm Port
Press Enter to Clear SOFT fault - the loader code cannot find an available
serial port for performing the download operation. F
F003 Could Not Open Comm
Press Enter to Clear SOFT fault - could not open comm port (unused). F
F004 Host Sync Failed
Press Enter to Clear SOFT fault - loader timed out while waiting for the host
to echo back the sync bytes to validate the serial
channel. F
F005 Invalid H/W Config.
Press Enter to Clear unused F
F006 Incompatible Image
Press Enter to Clear SOFT fault - host aborted download due to an
incompatible image. F
Table 0–1 Fault Symptom Codes