2
-34
Wiring the PG-B2
Wiring examples are provided in the following illustrations for the PG-B2.
•
Shielded twisted-pair wires must be used for signal lines.
•
Do not use the pulse generator's power supply for anything other than the pulse generator (encoder).
Using it for another purpose can cause malfunctions due to noise.
•
The length of the pulse generator's wiring must not be more than 100 meters.
•
The direction of rotation of the PG can be set in user constant F1-05. The factory preset if for forward
rotation, A-phase advancement.
Fig 2.25 PG-B2 Wiring
•
When connecting to a voltage-output-type PG (encoder), select a PG that has an output impedance with
a current of at least 12 mA to the input circuit photocoupler (diode).
•
The pulse monitor dividing ratio can be changed using constant F1-06.
Fig 2.26 I/O Circuit Configuration of the PG-B2
Three-phase 200
VAC (400 VAC)
Inverter
Power 12 V
Power supply 0 V
A-phase pulse output (+)
A-phase pulse output (-)
B-phase pulse output (+)
B-phase pulse output (-)
A-phase pulse monitor output
B-phase pulse monitor output
PG power
12 V
A-phase pulse
input
B-phase pulse
input
A-phase
pulses
B-phase
pulses
D
ivision
r
a
te
cir
cuit
B-phase pulse
monitor output
A-phase pulse
monitor output
A-phase pulses
B-phase pulses
Summary of Contents for VARISPEED G7 -
